Banner
Home > News Center > Content
Controlling the high quality of Dongguan precision cast steel is the key
- 2020-03-20-

Dongguan Precision CastingSteel is a general term for steel castings produced from various stainless steel materials, and is mainly used under various corrosive conditions. In the production process, how can we effectively control the quality of its production? Let's learn from the following articles:

1. When bonding, two pull ribs are set at the 220mm opening on the slope of the shell. When bonding the ribs, check and calibrate the 220mm opening dimension to make it meet the requirements.

2. Mould structure design. If the arc-shaped plate of the coffee machine accessories is manufactured by itself, and then glued with the opening dustpan, the mold structure is very simple, but the amount of deformation will be greater. In order to reduce the deformation, the entire appearance is manufactured. Although there are two more inwardly inclined cores on the punch, the structure is more messy, but the deformation can be reduced. At the same time, a 15mmx20mm reinforcing rib is added under the easily deformable arc-shaped plate, and the transition fillet radius between the arc-shaped plate and the main mold is added from 0mm to 30mm.

3. Appropriately lower the sand adding speed and oscillation acceleration when the loose sand is firm. Through the above summary measures, the scrap rate of robot stainless steel parts is almost zero. Other process parameters of the clutch housing.

4. When the foam appearance is formed, adopt multi-gun pressure to send the material, adjust the water spray amount of the upper and lower cooling water pipes, so that the upper and lower cooling pipes are uniformly cooled; negative pressure dehydration, the appearance is set in the mold; multi-point vacuum suction cups take the mold.

As long as we have a good grasp of the four points we have already mentioned, we are the best to control the quality of stainless steel casting, and the quality of the production meets the requirements, so that we can use it and maximize the benefits.

Stainless steel precision casting or investment casting, silica sol process. It is a low-cut or no-cutting casting process. It is an excellent process technology in the robot stainless steel parts casting industry. Its application is very wide. It is not only suitable for casting of various types and alloys, but also produced castings. The dimensional accuracy and surface quality are higher than other casting methods, and even the complex, high-temperature resistant, and difficult-to-process castings that are difficult to cast by other casting methods can be cast by investment casting.