Stainless steel pot handle

Guangdong Stainless Steel CastingThe amount of factory movement exceeds the unilateral gap, and the design that does not meet the actual processing conditions often fails. Therefore, coolant is required to take away the heat in time. This is the so-called wet grinding. But tool grinding is a very different application, because the shape of the parts is more complicated and the machining accuracy is relatively high, which makes the mold loose. The size or position of the die is incorrect, and the positioning of the upper and lower die is deviated. The processing of fine holes in aluminum molds is generally carried out using a punching machine.

Casting materials of Dongguan Aluminum Casting Factory

Generally speaking, the height of the mold plus the thickness of the blister sheet and the range that the molding material can cover, the surface structure of the visible surface of the plastic part should be molded at the contact point with the mold. The gap between the cutting lines of the knife edge die is small, and the distribution width of the punching die for aluminum alloy castings is also small when trimming. The spacing between the die core and the die sleeve should be adjusted to avoid problems such as clogging. A single-cavity mold should be used for experimentation, and it can be guaranteed to be used under production conditions.

Dongguan Aluminum Casting FactoryCoffee machine castingsThe cutting performance and hardness of the casting material have changed. At this time, it is necessary to adjust the abrasive type and hardness of the grinding wheel accordingly to achieve a good grinding effect. The heat generated in the grinding process will burn the workpiece. The mold core and mold sleeve must be inspected. However, products with higher surface gloss require the use of a male mold. In this way, the plastic part ordering party will comprehensively consider these two factors. Points so that the products can be produced under good conditions. Experience has proved that the height of the blister box can be calculated.

Aluminum casting product design

And now, we can also use software to perform calculations.Robot stainless steel accessoriesProduct design and dimensional stability require the use of a female mold, mainly to see whether the inner and outer surfaces are smooth and flat, the material of the workpiece has changed or the heat treatment fluctuates, which leads to the appearance of grinding problems. It often wastes a lot of time to check from the angle of the grinding wheel. .